Laboratory and Field Evaluation of Measurement Methods for One-Hour Exposures to O3, PM25, and CO

ABSTRACT

While researchers have linked acute (less than 12-hr) ambient O₃, PM₂₅, and CO concentrations to a variety of adverse health effects, few studies have characterized short-term exposures to these air pollutants, in part due to the lack of sensitive, accurate, and precise sampling technologies. In this paper, we present results from the laboratory and field evaluation of several new (or modified) samplers used in the “roll-around” system (RAS), which was developed to measure 1-hr O₃, PM₂₅, and CO exposures simultaneously. All the field evaluation data were collected during two sampling seasons: the summer of 1998 and the winter of 1999.

To measure 1-hr O₃ exposures, a new active O₃ sampler was developed that uses two nitrite-coated filters to measure O₃ concentrations. Laboratory chamber tests found that the active O₃ sampler performed extremely well, with a collection efficiency of 0.96 that did not vary with temperature or relative humidity (RH). In field collocation comparisons with a reference UV photometric monitor, the active O₃ sampler had an effective collection efficiency ranging between 0.92 and 0.96 and a precision for 1-hr measurements ranging between 4 and 6 parts per billion (ppb). The limits of detection (LOD) of this method were 9 ppb-hr for the chamber tests and ~16 ppb-hr for the field comparison tests.

PM_2.5 and CO concentrations were measured using modified continuous monitors—the DustTrak and the Langan, respectively. A size-selective inlet and a Nafion dryer were placed upstream of the DustTrak inlet to remove particles with aerodynamic diameters greater than 2.5 um and to dry particles prior to the measurements, respectively. During the field validation tests, the DustTrak consistently reported higher PM_2.5 concentrations than those obtained by the collocated 12-hr PM_{2 5} PEM samples, by approximately a factor of 2. After the DustTrak response was corrected (correction factor of 2.07 in the summer and 2.02 in the winter), measurements obtained using these methods agreed well with R² values of 0.87 in the summer and 0.81 in the winter. The results showed that the DustTrak can be used along with integrated measurements to measure the temporal and spatial variation in PM_{2 5} exposures. Finally, during the field validation tests, CO concentrations measured using the Langan were strongly correlated with those obtained using the reference method when the CO levels were above the LOD of the instrument [~1 part per million (ppm)].     

Analysis of a Farquhar-von Caemmerer-Berry leaf-level photosynthetic rate model for Populus tremuloides in the context of modeling and measurement limitations

The balance of mechanistic detail with mathematical simplicity contributes to the broad use of the Farquhar, von Caemmerer and Berry (FvCB) photosynthetic rate model. Here the FvCB model was coupled with a stomatal conductance model to form an [A,g_s] model, and parameterized for mature Populus tremuloides leaves under varying CO₂ and temperature levels. Data were selected to be within typical forest light, CO₂ and temperature ranges, reducing artifacts associated with data collected at extreme values. The error between model-predicted photosynthetic rate (A) and A data was measured in three ways and found to be up to three times greater for each of two independent data sets than for a base-line evaluation using parameterization data. The evaluation methods used here apply to comparisons of model validation results among data sets varying in number and distribution of data, as well as to performance comparisons of [A,g_s] models differing in internal-process components.     

Comparison of Statistical Designs and Experimental Protocols Used to Evaluate Rain Acidity Effects on Field-Grown Soybeans

Published results of four field experiments testing effects of acidic precipitation in field-grown soybeans have led to contradictory conclusions. This paper examines the experimental procedures and protocols of the four experiments which could have contributed to differences in both the reported crop yields and the interpretations or conclusions drawn from the experiments.

The most important difference among the experiments is in their statistical designs. Two of the field layouts used only one plot per treatment, providing replication only for plants, rows or sectors within plots, but not among plots. By using real data from a highly replicated experiment it is shown that with such deficient statistical designs treatment effects cannot be separated from other microenvironmental variables peculiar to a specific plot location.

The other two experiments were highly replicated. They were designed to detect differences of approximately 10% among treatment means. Type 1 error, a, was predetermined, and replication was sufficient to keep type 2 error low. This design was made possible because a preliminary experiment was available to estimate the expected components of variance. Despite differences in the procedures and protocols among the four experiments, it is primarily the quality of the experimental design which has determined their validity and relative utility for crop loss assessment.     

Spatial Variation in Acidic Sulfate and Ammonia Concentrations within Metropolitan Philadelphia

Abstract

Acidic sulfate concentrations were measured in metropolitan Philadelphia during the summers of 1992 and 1993, as part of a continuing effort to characterize particle concentrations in urban environments. Sampling was performed simultaneously at eight sites located within and around metropolitan Philadelphia. Sites were selected based on their population density and on their distance and direction from the city center. Air pollution sampling was conducted every other day during the summer of 1992 and every day during the summer of 1993. All samples were collected for 24-h periods beginning at 9 a.m. (EDT). All acidic sulfate and ammonia samples were collected using modified Harvard-EPA Annular Denuder Systems (HEADS).

In this paper, we examine the spatial variation in acidic sulfate and ammonia concentrations within the metropolitan Philadelphia area. We also identify factors that may influence their variation and develop models to predict their concentrations. Outdoor sulfate (SO₄ ^2?) concentrations were uniform within metropolitan Philadelphia; however, aerosol strong acidity (H⁺) concentrations varied spatially. This variation generally was independent of wind direction, but was related to local factors, such as the NH₃ concentration, population density, and distance from the center of the city. Physico-chemical models, which were developed using data collected during the summer of 1992, were excellent predictors of 24-h and mean summertime H⁺ concentrations measured during the summer of 1993. Models accounted for 78% of the variation in 24-h H⁺ levels. Results suggest that a single stationary ambient (SAM) monitor would be sufficient to estimate SO₄ ^2? exposures for populations living in Philadelphia. For H⁺, however, multiple monitoring sites or models should be used to determine the outdoor H+ exposures of populations living in urban environments, although a single SAM site may provide an excellent index of H⁺ variation over time.     

Phytoremediation of an arsenic-contaminated site using Pteris vittata L. and Pityrogramma calomelanos var. austroamericana: a long-term study

This field study investigated the phytoremediation potential of two arsenic (As) hyperaccumulating fern species, Pityrogramma calomelanos var. austroamericana and Pteris vittata over 27-month duration at a disused As-contaminated cattle-dip site located at Wollongbar, NSW, Australia. Ferns planted in January 2009 were harvested following 10, 22 and 27 months of growth. A detailed soil sampling was undertaken in June 2009 (initial, n?=?42 per plot) and limited sampling in April 2011 (after 27 months, n?=?15 per plot) to measure total and phosphate-extractable As concentrations in soil at 0?-?20-, 20?-?40- and 40?-?60-cm depths. The choice of the limited number of samples was considered sufficient to estimate the changes in soil As concentration following phytoremediation based on a geostatistical model. The average frond dry biomass, As concentration and As uptake were significantly (P??0.05), respectively, by P. vittata. Our results show that phytoremediation time based on observed changes in soil As based on limited sampling is not reliable; hence, it is recommended that the frond As uptake should be considered in order to evaluate the phytoremediation efficiency of the two fern species at the experimental site. Using As uptake of the two fern species, we estimate that with P. calomelanos var. austroamericana it would take 55?-?125 years to decrease mean total As content below the ecological investigation level (20 mg kg(-1)) in the surface and subsurface soils, whereas with P. vittata 143?-?412 years would be required to achieve this target.     

Terrain Discontinuity Effects in the Regional Flow of a Complex Karstified Aquifer

Karst aquifers are characterized by spatial heterogeneity due to the presence of highly permeable channels and conduits in low-permeable fractured rocks (matrix block). Recent studies have reported a close relationship between surface and subsurface water in karstic regions due to the water flow through a complicated network of paths formed by fracture intersections. Subsurface flow in karstified aquifers ranges between conduit flow, in large passages with relatively high flow velocities, and diffuse flow, in the matrix block where Darcy’s law is still valid. In this paper, we present the simulation of a complex karstified aquifer system in Crete, Greece, where the presence of main faults drastically affects the regional flow. A discrete fracture approach in conjunction with an equivalent porous medium approach was adopted to simulate the mixed flow in the area of interest. The simulation results have shown that the length and the orientation of the dominant faults, primarily during the rainy season, affect the flow field.     

SWOT Analysis and Challenges of Nile Basin Initiative：An Integrated Water Resource Management Perspective

River Nile is one of the longest transboundery rivers and it is shared and used by Burundi,Democratic Republic of Congo,Egypt,Ethiopia,Eritrea,Kenya,Rwanda,Sudan,Tanzania and Uganda.As of today,the Nile is a crucial resource for the economic development of the Nile Basin countries and a vital source of livelihood for 160 million inhabitants as well as 300 million people living in the 10 riparian countries.The Nile Basin Initiative(NBI) is one of the international cooperative river basin management program and regional partnership where all the Nile Basin countries except Eritrea unite to pursue long-term sustainable development,improved land use practices and management.This review therefore focused on the challenges not faced on NBI in terms of integrated use of the river and conducted analysis of strengths,weaknesses,opportunities and threats(SWOT) based on secondary data.The result of the review revealed that for decades,the Nile Basin people have been facing many complex environmental,social,economic and political challenges that have made it difficult for the proper management and sustainability of Nile water.The initiative provides training to develop skills in government ministries,non-governmental organizations and local communities in each country.It is also working to raise awareness of critical environmental issues by strengthening networks of environmental education practitioners;developing curriculum in the education sector.The challenges of NBI include the involvement and funding of World Bank,lack of sufficient staff,procedural and policies conflicts,lack of coordination and linkage with other regional institutions and lack of recognition as river basin organization.Considering the complex nature of the project,it is recommended that the NBI should come up with a strong multi-disciplinary monitoring and evaluation team to follow up all implemented projects.The NBI should carry out participatory land use planning in communities along the river basin.Moreover,livelihood analysis should be carried out especially in communities along the Nile to come up with poverty eradication projects which are socially acceptable,applicable,economically viable and affordable.     

Impact of water quality on bacterioplankton assemblage along Cértima River Basin (central western Portugal) assessed by PCR–DGGE and multivariate analysis

The information on bacterial community composition (BCC) in Portuguese water bodies is very scarce. Cértima River (central western Portugal) is known to have high levels of pollution, namely organic. In the present work, the BCC from a set of 16 water samples collected from Cértima River Basin and its main tributaries was characterized using 16S rDNA–denaturing gradient gel electrophoresis, a culture-independent molecular approach. Molecular data were related to environmental parameters through multivariate analysis to investigate potential impact of water pollution along the river. Principal component analysis using environmental data showed a water quality gradient from more pristine waters (at the mountain tributaries) to waters with increasingly eutrophic potential (such as Fermentelos Lake). This gradient was mainly defined by factors such as organic and inorganic nutrient sources, electrical conductivity, hydrogen carbonate concentration, and pH. Molecular results showed variations in BCC along Cértima River Basin but in the main river section, a Bacteroidetes phylotype (Flavobacterium sp.) proved to be dominant throughout the river course. Multivariate analysis suggests that spatial variation of BCC along the Cértima River Basin depended mainly on parameters such as Chl a, total suspended solid (TSS), total organic carbon, electrical conductivity, and HCO _boxclose^-_{3}^{-} levels. Bacteroidetes phylotypes were all related to higher electrical conductivity and HCO₃^-_{3}^{-} levels although some of these were also correlated with high SO₄^2-_{4}^{2-} and others with high soluble reactive phosphorus, nitrate, TN, and Kjeld-N levels. The Gammaproteobacteria occurrence was correlated with high SO₄^2-_{4}^{2-} levels. One of the Betaproteobacteria phylotypes showed to correlate with low redox potential (E_h) and high temperature, pH, TSS, and Chl a levels while another one showed a negative correlation with Chl a values.     

A New Real-Time Isokinetic Dust Mass Monitoring System

A new real-time dust mass monitor has been developed by combining an automatic isokinetic sampling probe with a tapered element oscillating microbalance (TEOM). Fly ash from a room temperature wind tunnel is sampled through the isokinetic sampler and collected on an astroquartz mat filter in the TEOM detector. The filter is first excited and oscillated at low frequency (about 200 Hz). As the particles deposit on the filter, the mass increase of the filter is reflected in a frequency reduction which yields the collected particle mass directly in real time. The TEOM detector normally has a high mass resolution (10^?9 g) and wide dynamic range (105⁵–106⁶). It is desensitized for high particle loading applications. Good agreement has been obtained between the mass collected through the isokinetic sampling system and the weight loss of the dust feeder, in real time. The body of information presented in this paper is directed to those concerned with particle emission and control in fossil fuel combustion systems.     

1987 Joint EPRI/EPA Symposium on Stationary Combustion NOX Control

From March 23rd to 26th, 1987, the city of New Orleans hosted 350 attendees, including representatives from 15 foreign countries, at the 1987 Joint Symposium on Stationary Combustion NO_x Control. Cosponsored by the Electric Power Research Institute (EPRI) and the U.S. Environmental Protection Agency (EPA), the symposium provided attendees the opportunity to hear 49 papers in nine sessions covering technological and regulatory developments on NO_x control in the United States and abroad since the May 1985 symposium in Boston. Session topics included general environmental issues, low-NO_x combustion equipment (i.e., low-NO_x burners, reburning, etc.), flue gas treatment, fundamental combustion research, and special issues for cyclone coal-fueled boilers, oil- and gas-fired boilers, and industrial combustion applications.

Advances to the state-of-the-art presented at this symposium include: improved and/or newly applied combustion modifications for pulverized coal-fired boilers; further analyses of reburning, the leading combustion modification option for cyclone-equipped boilers; initial experiences with catalytic flue gas treatment in Europe; studies of NO_x control retrofit options for oil- and gas-fired utility systems; and new technology developments for coal, oil, and gas fueled utility and industrial combustors.

This paper summarizes those presentations that discussed significant changes since May 1985 in areas of potential interest to EPRI and its utility members. Where appropriate, they include our perspectives on the applicability of these newly disclosed findings to utility systems.